Troubleshooting - Insignia NS-A2111 Guia Del Usuario

Welcome
4 To select Mono or Stereo while in FM mode, press the
MO/ST button. When you select Stereo, the display shows a
stereo signal. If the signal is not strong enough, you cannot select
Stereo.
Note
5 Press ENTER to exit FM/AM mode and enter disc play mode.
6 Change the antenna direction to find the strongest signal for each
station.

Troubleshooting

Note
For your convenience, we have listed some methods to solve
common problems you may encounter when using the system. If the
problem occurs repeatedly, contact your nearest maintenance center.
Problem
Cannot operate the system
with the remote control
Cannot play discs
No disc menu is displayed
Play mode is different from
what has been chosen in
the Setup menu
Picture distortion or no color
displayed
No picture is produced or
picture is produced
asynchronously
Stereo is not available in AM mode.
In most cases, whether the DVD player can work correctly
depends on the disc you are trying to play. Some features
listed in the instruction manual may not work properly due to
disc problems.
Cause and solution
• Check the batteries in the remote control to see if
they need to be replaced.
• Use the remote control within 6 meters from the
system, and direct the remote control to the front
panel of the system.
• Make sure that the disc is placed on the tray with
the label facing up.
• Play discs compatible with the DVD player.
• Switch off the player for a while and switch on
again.
• Parental control rating is set. Remove or change
the rating.
Check if a menu is recorded.
If the disc has no corresponding function codes, some
features selected in the Setup menu may not work
properly.
The TV system or video output of the system is not the
same as the TV set. Reset the TV system.
The setup of the video output does not match the way
the system is connected with the TV set. Set up and
configure correctly.
www.insignia-products.com 27