Troubleshooting - Walgreens DELUXE WRIST WGNBPW-720 Manual De Instrucciones

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
SYMPTOMS
Unit does not turn on when
the START/STOP
button is pushed.
EE measurement error
symbol shown on display
or the blood pressure value
(or high).
display
display
display
display
EP error symbol shown on
display
U
error symbol
appears on
display
Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance
should you disassemble or attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on the warranty page.
POSSIBLE
CAUSES
Batteries have
run down.
Battery polarities have been
positioned incorrectly.
Cuff has been placed incor
rectly.
Did you talk or
move during
measurement?
Shaking of the wrist with the
cuff on.
Air circuit
abnormality.
Error determining measure
ment data.
Component malfunction.
System error.
Wrist is not in the ideal
position.
34
CORRECTION
Replace them
batteries.
batteries in the
correct positions.
Wrap the cuff properly so that it
is positioned correctly. Measure
again.
Keep wrist steady during
measurement. Measure again.
Measure again.
Switch the unit off, then measure
again.
Measure again.
Measure again.
Measure again.
Measure again. Once the wrist
positioning sensor guides your
wrist to your ideal location, keep
arm still until measurement is
complete.