Non -Ducted Installation; Light Bulbs Replacement - Best UP27I Serie Instrucciones De Instalación

13.REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS
Reinstall the grease drip rail.
Remove protective plastic film covering Evolution™ hybrid baffle filters before installing them.
13.1 D I
UCTED NSTALLATION
Reinstall Evolution™ hybrid baffle filters on the hood.
13.2 N -D I
ON UCTED NSTALLATION
Slide out and discard the secondary micromesh filters from the back of the baffle filters. Slide in the charcoal filters included
in the non-duct kit. Reinstall the baffle filters on the hood.
It is recommended to install side filters first and finish with center one.
1. Insert one end of Evolution™ hybrid baffle filter
into the front channel of the hood.
2. Raise the other end toward the inside of hood and
insert in the grease drip rail of the hood.
Replacement filters are available from your dealer. See
label inside hood for size and part number.
For charcoal filter replacement kit, see table on page 15.

14.LIGHT BULBS REPLACEMENT

In order to prevent the risk of personal injury, do not install a lamp identified for use only in enclosed fixtures.
This hood must use 120 V, 50 W, MR16 or PAR16 with GU10 base, shielded halogen lamps (included).
In order to prevent the risk of personal injury, the halogen lamps must be cooled down before removing them.
1. To remove lamps, gently push upwards and turn counterclockwise
to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip
when removing the bulb.
2. Install the new lamps by placing the bulb leads into their
grooves in the socket.
3. Gently push upwards and turn clockwise until secure.
CAUTION
:
:
WARNING
!
WARNING
!
- 12 -
HD0214
1
HD0209
1
HO0089
2
2 3