Prepare The Installation - Best UP27I Serie Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. PREPARE THE INSTALLATION

When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses
and gloves.
Remove the installation kit from inside the hood.
Make sure that the following items are included:
- Installation manual
- Adapter/damper 3¼" x 14" to 3¼" x 10" (exclusively for UP27I Series range hoods, temporarily assembled to pan, behind
Evolution™ hybrid baffle filters)
- Adapter/damper 3¼" x 14" (exclusively for UP27I Series range hoods, temporarily assembled to pan, behind Evolution™
hybrid baffle filters)
- Right and left flow deviators (exclusively for UP27I Series range hoods)
- Accessories including:
• 3 Evolution™ hybrid baffle filters
• Shielded halogen lights (GU10 type base, 120 V, 50 W) (2 for hoods up to 36" width, 4 for hoods from 42" to 48" width)
• Bag of parts including:
(4) no. 10-32 lock nuts, (1) electrical cable clamp, (8) no. 8 x 1/2" double thread screws, (2) wire connectors,
(2) no. 6 x 1/2" standard screws, (6) no. 8 x 3/8" screws.
Parts sold separately:
- In-line blower assembly ILB3, ILB6, ILB9 or ILB11 (all include transition and rough-in plate, exclusively for UP27E Series range hoods)
- Exterior blower assembly EB6, EB9, EB12 or EB15 (all include rough-in plate, exclusively for UP27E Series range hoods)
- Transitions, duct, elbows, dampers, wall and roof caps. Refer to pages 3 and 4 for a complete list of venting options and
model numbers
- Non-duct kit ANKUP Series, mandatory for non-ducted installation (exclusively for UP27I Series range hoods).
3. REMOVE THE FILTERS
Remove tape on baffle filters.
Remove baffle filters from hood by pushing them towards
the front of hood (1) and rotating downward (2).
Set aside filters.
NOTE: It is recommended to start with the central one.
4. REMOVE BOTH ADAPTER/DAMPERS (UP27I SERIES RANGE HOODS ONLY)
Disassemble both adapter/dampers (shaded parts on illustration beside) from
hood pan by removing their retaining screws (2 screws per adapter and
damper). Discard the screws.
WARNING
!
1
HD0206
- 6 -
2
A
/
DAPTER
DAMPERS RETAINING
SCREWS LOCATION
HD0211

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Up27e serie

Tabla de contenido