Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. REMOVE THE GREASE DRIP RAIL
Remove tape on grease drip rail. Lift out grease drip rail and set aside.
6. REMOVE THE PAN
Using a Phillips no. 2 screwdriver, remove the screws retaining the pan (shaded parts on illustration below) to the hood. Remove
the pan and set aside.
NOTE: There are 2 screw models for UP27I pan retaining screws; the flat end type (A) (n°. 8 x 3/8") are shorter and located
near the front of the hood and the pointed end ones (B) (n°. 6 x 1/2") are longer located in the middle of the hood. UP27E
pan retaining screws are all the same.
UP27I R
A
HD0207
7. PREPARE THE CABINET
For cabinets with recessed bottom, attach two wood filler strips cut to length (not included), on each side, as shown below. See
table below for wood filler strips location.
H
WIDTHS
30"
36"
42"
48"
ETAINING SCREWS LOCATION
A
A
B
B
B
A: no. 8 x 3/8"
B: no. 6 x 1/2"
C
OOD
ENTER OF WOOD
(A)
STRIP LOCATION
13
3
⁄
"
8
16
3
⁄
"
8
19
3
⁄
"
8
22
3
⁄
"
8
UP27E R
A
A
HD0208
- 7 -
HD0212
ETAINING SCREWS LOCATION
A
A
A
A: no. 8 x 3/8"
L C
A
A
Publicidad
Tabla de contenido
