8. PREPARE THE HOOD (DUCTED INSTALLATION ONLY)
8.1 UP27I S
ERIES RANGE HOOD
H
D
(
ORIZONTAL
ISCHARGE
Using 3 no. 8 x 3/8" screws provided with hood, secure the adapter/damper
on the back of the hood. Remove tape from damper flap.
Seal the adapter/damper and the metal shut-off plate to the hood using
duct tape.
8.2 UP27E S
ERIES RANGE HOOD
Run house wiring (120 V AC) to installation location. Refer to the instructions
included with the selected blower/rough-in kit (sold separately) for details
on installing the rough-in plate. Install the rough-in plate so that the wiring
box is located on the right side as you are facing the hood.
9. CONNECT WIRING
Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all
applicable codes and standards. Before connecting wires, switch power off at service panel and lock
service disconnecting means to prevent power to be switched on accidentally.
9.1 UP27I S
ERIES RANGE HOOD
Run house wiring (120 V AC) to installation location. Place the electrical cable clamp, insert the cable in the hood and
tighten the electrical cable clamp to secure the cable. Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare
wire under GREEN ground screw.
9.2 UP27E S
ERIES RANGE HOOD
Remove wiring cover from rough-in plate and set aside.
Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw.
Reinstall wiring cover on rough-in plate.
(
INTERNAL BLOWER
'
)
CONT
D
(
EXTERIOR OR IN
(
INTERNAL BLOWER
(
EXTERIOR OR IN
)
(
'
)
CONT
D
-
)
LINE BLOWER
WARNING
!
)
-
)
LINE BLOWER
- 10 -
(CONT'D)
T
OP OF HOOD
A
/D
DAPTER
AMPER
S
L
CREW
OCATION
HD0204
HD0205
W
IRING COVER
R
-
OUGH
IN PLATE
ON TOP OF HOOD
L
OCKNUTS
HD0210
B
ACK OF HOOD