Tornado P Serie Manual De Operaciones Y Mantenimiento página 7

UNCRATING
Your Ultra High Speed Burnisher was protectively
packed to prevent damage in shipment. We suggest that
upon removing the unit from its carton you carefully
inspect it for any possible damage in transit. If damage
is discovered, immediately notify the transportation
company who delivered your machine. As a
manufacturer, we are unable to ace upon any claim for
concealed damage: you must originate the claim.
IMPORTANT SAFEGUARDS
This machine is designed to be safe when used to
perform the functions specified in this Operator's
Manual. Should damage occur to electrical or
mechanical parts, the machine should be repaired by
the manufacturer or competent service center before
using in order to avoid further damage to the machine
or physical injury to the user. Your floor machine is
equipped with a safety switch lockout device designed
for your safety. Do not attempt to bypass or defeat the
safety lockout device. Never use any device to lock the
power switch in the ON position.
APPLICATION
The P1600 and P2000 Glazers High Speed Burnishes
are used to achieve and /or maintain a high floss
appearance on an established floor finish. The high pad
revolution of the floor burnisher combined with a good
polishing pad will turn properly established cleaned
floor finish into a high gloss, hardened finish known as
the 'wet look shine". Recommended pads are beige or
white synthetic pads, or the natural hogs hair blended
pads.
Preparation of the Surface
Before each use of this machine, the floor must be dust
mopped with a treated mop and if necessary clean the
floor with a damp mop using a solution of water and
neutral cleaner.
PREPARE THE MACHINE FOR OPERATION
.WARNING
To prevent injury, always remove the electrical plug
from the electrical outlet before changing the polishing
pad and before leaving the machine.
With the handle locked, tip the machine back until the
handle is lying flat on the floor
To remove the pad-lock pad holder from the flexible
pad driver, grasp the center support with your thumb
and forefinger and turn the collar counter-clockwise
(see figure 1).
Place a clean or new 230" buffing pad over the
alignment ring on the pad holder
Replace the collar by turning clockwise until snug (see
figure 2).
Step back and tilt the burnisher to the upright position.
Connect the power cord into a grounded, 3-wire outlet.
The P1600 and P2000 Glazers should be operated
with the handle in the unlocked "floating" position to
provide excellent maneuverability and automatic pad
contact. The P1600 and P2000 Glazers are designed to
maintenance of large, open areas. To prevent excessive
pad drag or uneven burnishing where tight, repetitive
turns are necessary, lock the handle for manual control
of pad contact
. NOTE: The hardened steel cam release lever does
not require extreme tightening to effectively hold the
handle in position. Over-tightening the can release
lever will shorten the functional life of the lever (see
figure 3).
7
figure 1