Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
figure 2
HOW TO OPERATE THE MACHINE
Plug the machine in as directed and lower the handle
to the desired operating height and lock in place using
the cam lever handle. Push the safety switch forward
(see figure 4) and squeeze the switch triggers beneath
the handle grips. This activates the motor and stars the
pad in operation. Each time your release the triggers
the safety switch will reset. You will need to follow
the direction above to restart the machine. CAUTION:
When leaving the machine unattended, disconnect the
wall plug and return the handle to the "locked" upright
position to prevent accidental starting.
Push the machine forward in a straight line, at a slow
walking speed. Overlap each pass by about 1 inch
(25mm).
AFTER USING THE MACHINE
Upon completion, dust mop with treated mop to pick up
all burnishing residue.
The condition of the floor pad has a direct effect on the
performance of your burnisher. When the pad becomes
dirt, turn it over and use the other side. When finished,
was the pad out and allow it to dry completely before
using again.
TRANSPORTING THE MACHINE
Use the rear wheels for transporting the P1600 and
P2000 Glazers. This will insure that the operating
wheels remain clean and smooth for use on clean floor
surfaces (see figure 5).
8
figure 3
figure 4
figure 5
Publicidad
Tabla de contenido
