Filtration Process; Requirements; Operation Notes; Starting The Filtration Process - VITO 30 Operación Manual

3. The indicators show the selected status:
Red LED (1) = beeper off
Green LED (2) = half volume
Red LED + green LED = full volume (1) + (2)
Pull out the power cord (8).
The new settings are now saved.

8. Filtration process

8.1 Requirements

VITO® 30 / 50 / 80
• Insert particle filter into the pump-filter unit (9) (See chapter 11 Particle filter change.)
• Latch filter-lid
• Put Electrical unit (6) on pump-filter unit (9)
• Tighten the star handles (5).

8.2 Operation notes

• Filtration cycle can be stopped at any time by pressing push button (3).
• Do NOT move VITO® while filtration is in progress!
• Only use VITO® in a straight position!
• The Power indicator (red LED) (1) and Filtration indicator (green LED) (2) are lit during
filtration process.

8.3 Starting the filtration process

1. Make sure that the particle filter is in the pump-filter unit (9)
2. Take VITO® out of the drip pan (4)
3. Put VITO® into the fryer.
4. Ensure a secure standing (for holding brackets see chapter 12 Accessories)
5. Check the frying oil level
(The oil level must be between the MIN and MAX marking of the pump-filter unit (9)!)
6. Plug in VITO®:
Power indicator (red LED) (1) is active
Cooling fan is running (VITO®50 / VITO® 80)
7. Press push button (3)
8. Filtration indicator (green LED) (2) is lit during the filtration.
8.4 Finish the process prematurely
1. Press push button (3)
Filtration indicator (green LED) (2) is off
2. Pull the power cord (8): VITO® 30
Keep VITO® 50 / VITO® 80 plugged in!
3. Lift VITO®, let oil flow back in the fryer
4. Place VITO® in the drip pan (4)

9. Safety functions

9.1 Tilt and vibration protection (VITO® 80 only)
If VITO® 80 is tilted more than 15°, topples over or vibrates too strong because of bad placement or
mechanical defect, the machine will switch off. Both indicators start flashing and a repeating beep will
be heard.
9.2 Acoustic signal (VITO® 80 only)
At the end of each cycle VITO® 80 beeps for 5 seconds. VITO® 80 will also beep if any error occurs.

9.3 Temperature control

If the temperature of the electrics is exceeded, VITO® stops the filtration.
The power indicator (red LED) (1) starts to flash and VITO® 80 starts to beep continuous.
VITO® must be taken out of the fryer to confirm the error by pressing the push button (3)
The power indicator (red LED) (1) will continue to flash until VITO® is cooled down.
Leave VITO® 50 & VITO® 80 plugged in. VITO® is operational again after approx. 15 min.
It takes up to 2.5 hours if VITO® is unplugged.
Page 5