If VITO® takes too long to cool down after a temperature based shutdown, the ambient temperature might
be too high or VITO® was left in the fryer. VITO® 80 will continue to beep every 40 seconds. Take VITO® to a cool
place and plug it back in to allow the cooling fan to work.
Do NOT put VITO® into a cold-storage room! Condensation can destroy the electrics.
9.4 Memory
VITO® records the operating times and usage values. These values can be readout using the VITO® Data Reader.
(see chapter 12 Accessories)
10. Care and servicing
10.1 Notes
•
Clean pump-filter unit (9) at every particle filter change
•
Clean VITO® only if cooled down
•
Do NOT use abrasives
•
Do NOT use wire brushes or similar tools
10.2 Cleaning preparation
1. Make sure VITO® is cooled down
2. Unfasten star handles (5) on both sides
3. Remove electrical unit (6) from pump-filter unit (9)
4. Open pump-filter unit (9)
5. Dispose particle filter
6. Manual or machine cleaning
10.3 Manual cleaning
1. Clean electrical unit (6) only with damp cloth!
2. DON'T put VITO® under running water! This can destroy the electrics!
3. Clean the pump-filter unit (9) with soap sud.
4. Dry VITO® with a towel.
10.4 Machine cleaning
1. Clean electrical unit (6) only with a
damp cloth! Do NOT put the electrical
unit (6) into a dishwasher!
This will destroy the electrics
2. Put pump-filter unit (9) and the drip pan (4)
into the dishwasher. Start the cleaning program..
11. Particle filter change
Change the particle filter only if necessary. The time of change is based on usage of VITO® and the
degree of pollution of the frying oil.
Normal flow
Pay attention to the cleaning efficiency and the spill of oil coming out of the pump-filter unit. (9)
Change the particle filter only at a low filtration performance.
Page 6
Low flow