Keystone Correction (Correcting Trapezoidal Distortion) - Sharp PG-A10X Manual De Instrucciones

Keystone Correction (Correcting Trapezoidal Distortion)

Correcting Trapezoidal
Distortion
This function allows for Keystone (On-screen
Trapezoidal Distortion) Correction.
Note
• When the image is projected either from the
top or from the bottom towards the screen
at an angle, the image becomes distorted
trapezoidally.
The function for correcting trapezoidal dis-
tortion is called Keystone Correction.
• The Keystone Correction can be adjusted up
to an angle of approximately ±35 degrees.
1
Press .
• You can also use
2
Press ', ", \ and | to adjust
the Keystone correction.
• You can also adjust the Keystone cor-
rection using the
tons on the projector.
Note
• Since the trapezoidal distortion of the
image can be corrected up to an angle
of approximately ±35 degrees, the ac-
tual screen can be diagonally set up
to that angle as well.
• Press
ting.
• Straight lines or the edges of images
may appear jagged while adjusting
the image.
3
Press .
• You can also use
Note
• You can use the same settings used
in NORMAL mode 4:3 for 16:9.
A10X_A10S#E_Print#p26_31.p65
on the projector.
or but-
to make the default set-
on the projector.
29
KEYSTONE
button
UNDO
button
Compresses
upper side.
Compresses
lower side.
03.2.4, 2:04 PM
', " , \, |
buttons
29