Controller Installation; Without External Fan; With External Fan - Varian Turbo-V 81-AG Serie Manual De Instrucciones

CONTROLLER INSTALLATION

The controller can be mounted in two way:
–

without external FAN

–

with external FAN.

To install the controller execute the following
procedures.
Without external Fan
See the following figure.
1. Turn the pump upside-down;
2. Place the square plate on the pump bottom;
3. Place the eight screws in the holes on the pump
bottom;
4. Tighten the screws properly;
5. Turn the pump again;
6. Place the pump aligning the 4 holes of the square
plate in the holes on the top of the controller;
7. Place the four screws on the top of the controller;
8. Tighten the screws properly;
9. Plug the line cord and connect the pump cable to
the pump;
10. Connect the mating connector with the jumper on
the interlock signal to start the pump.
With external Fan
The L-shaped bracket (P/N 969-9290) is available as
an option.
See the following figure.
1. Turn the pump upside-down;
2. Place the L-shaped bracket (with external FAN)
on the pump bottom;
3. Place the square plate on the L-shaped bracket
bottom;
4. Place the eight screws in the holes on the pump
bottom;
5. Tighten the screws properly;
6. Turn the pump again;
7. Place the pump aligning the 4 holes of the square
plate in the holes on the top of the controller;
8. Place the four screws on the top of the controller;
9. Tighten the screws properly;
10. Plug the line cord and connect the pump cable
to the pump;
11. Connect the mating connector with the jumper
on the interlock signal to start the pump.
38/50
TECHNICAL INFORMATION
NOTE
87-901-004-01 (B)