IMS Welding POWERDUCTION 37LG Manual De Instrucciones página 25

Translation of the original instructions
POWERDUCTION 37LG / 39LG / 50LG
Do not obstruct the machine's air intake, which facilitates air circu-
lation. Check the installation chapter before using the device.
Connection:
• This machine must be connected to an earthed socket.
• This machine is fuse-protected (39LG & 50LG).
• These Class A devices are not intended to be used on a residential
site where the electric current is supplied by the public network,
with a low voltage power supply. There may be potential difficul-
ties in ensuring electromagnetic compatibility on these sites, be-
cause of the interferences, as well as radio frequencies.
This hardware is compliant with the IEC 61000-3-12.
This equipment complies with the IEC 61000-3-11.
Maintenance:
• If the power cable is damaged, it must be replaced by the manu-
facturer, its after sales service or an equally qualified person to
prevent danger.
• Service should be performed by a qualified person.
• Warning! Always disconnect from the mains before performing
maintenance on the device.
• High Voltage and Currents inside the machine.
• If the internal fuse is melted, it must be replaced by the manufac-
turer (JBDC' dedicated sales service) or by an equally qualified
person to prevent any accidents.
• Remove the casing on a regular basis, to remove any excess dust.
Take this opportunity to have the electrical connections checked
by a qualified person, with an insulated tool.
• Do not use solvents or any agressive cleaning products.
• Clean the device's surfaces with a dry cloth.
Regulations:
Device complies with europeans directives.
The certificate of compliance is available on our website.
EAC Conformity marking (Eurasian Economic Community).
• Equipment in conformity with Moroccan standards.
• The declaration C‫( م‬CMIM) of conformity is available on our we-
bsite (see cover page).
Waste management:
This product should be disposed of at an appropriate recycling faci-
lity. Do not throw away in a domestic bin.
Ecopackaging symbol
«The product's manufacturer contributes to the recycling of its pac-
kaging by contributing to a global recycling system».
TRIMAN symbol
«This product should be recycled appropriately».
EN
25