Parts Identification; Operating Your Dehumidifier; Set Unit Upright - Dri-Eaz LGR 2800i Manual Para El Usuario

all doors and windows that open to the outside to
maximize the unit's water removal efficiency. Also, keep
traffic though the drying chamber to a minimum. Place
your LGR 2800i dehumidifier against a wall, away from

PARTS IDENTIFICATION

FIG. A: FRONT
Control panel.
FIG. C: POWER AND PUMP
ATTACHMENT POINTS
AA battery compartment. Provides
power to HygroTrac wireless
transmitter when unit is not plugged in.

OPERATING YOUR DEHUMIDIFIER

Set unit upright

NOTICE: If you transport a LGR 2800i dehumidifier in a
horizontal position, set it upright and let it stand for at
least 30 minutes before you turn it on. When the
07-01674B 2009-04
Molded pocket
for cord storage.
Humid air inlet
(both sides).
Process (dehumidified)
air outlet. May be used
with standard 12" rigid
or layflat ducting.
Power cord socket.
obstructions, and keep it away from anything that could
block airflow into and out of the unit.
For more information about creating an optimum drying
environment, contact Dri-Eaz at 800-932-3030.
FIG. B: REAR
Integrated handle.
Lower back panel. Remove
this panel to access the
pump for servicing.
FIG. D: PUMP ACCESS PANEL
Bottom of back
polyethylene housing.
Remove two bolts to
remove pump for cleaning.
machine is horizontal, the oil from the compressor flows
into the refrigerant coils reducing the ability of the
dehumidifier to function. Letting the unit stand upright for
30 minutes allows the oil to flow back into the
compressor.
3
Rugged rotomolded
housing resists d
and scratches and is
easy to maintain.
Drain hose pocket.
Lower back panel. Remove the
five retaining screws to remove
pump for cleaning.
Dri-Eaz Products, Inc.
ents