Use Procedure; Maintenance; Controller Startup; Starting The Pump - Agilent Technologies Turbo-V 1000HT Serie Manual De Instrucciones

16 Instructions for Use

Use procedure

Use procedure

Controller Startup

To startup the controller plug the power cable into a suitable power
source and set the line switch to the position 1.

Starting the pump

To start the pump press the START push-button on the controller
front panel.

Pump Shutdown

To shutdown the pump press the STOP push-button on the controller
front panel.

Maintenance

The Turbo-V 1000HT series controller does not require any
maintenance. Any work performed on the controller must be carried
out by authorized personnel. When a fault has occurred it is possible
to use the Agilent repair service. Replacement controllers are
available on an advance exchange basis through Agilent.
Before carrying out any work on the controller, disconnect it from the supply.
WARNING!
If a pump is to be scrapped, it must be disposed off in accordance
with the specific national standards.
232/310 Turbo-V 1000HT Controller User Manual / 87-900-894-01 (G)