Use Procedure
Controller Startup
To startup the controller plug the power cable into a suitable power
source and set the line switch to the position ON.
Starting the Pump
In order to start the pump, press the START pushbutton on the front
panel, after connecting it to the cable supplied with the controller
(from P31 connector to the pump).
Pump Shutdown
To shutdown the pump press the STOP push-button on the controller
front panel.
Maintenance
The Turbo-V 6000 series controller does not require any
maintenance. Any work performed on the controller must be carried
out by authorized personnel.
When a fault has occurred it is possible to use the Agilent repair
service. Replacement controllers are available on an advance
exchange basis through Agilent.
Before carrying out any work on the controller, disconnect it from the supply.
WARNING!
If a controller is to be scrapped, it must be disposed of in accordance
with the specific national standards.
Turbo-V 6000 Controller User Manual / 87-900-855-01 (F)
Instructions for Use
Use Procedure
201/274
16