Singer 288 Manual De Uso página 17

Changing Heeclle Plale.
NOTE: Remove bobbin if it contains thread in
order to prevem thread being caught when
plate is replaced.
• Raise needle to highest position bv turming
the hand wheel toward vou.
• Raise presser foot.
• Open slide plate. Place thumb under right
side of needle plate, lift it up and withdi'aw
it to right.
• Replace needle plate under clamping pin A.
push
it firrnlv
to the left and press down
until it snaps into place
• Close slide plate.
Attaching Snap-in Feed
Caver
E---..,
c
• Raise needle to highest position bv turning
hand wheel toward
vou.
• Raise presser foot, open slide plate and
insert general purpose needle plate.
• Slide snap-in feed cover awav frem
vou
over
needle plate until poirns B anel C are
positioned directlv over holes in needle
plate as illustrated. Snap in point B. Then
push point C in toward point B urrtil it
snaos into place. Close slide plate.
• To remove, open slide plate, then simplv lift
up front edge of feed cover and remove.
Close slide plate.
Changing lhe Heeclle
•
Raise needle to its highest posrnon bv
turning the hand wheel toward
vou.
Loosen
the needle-clamp screw D and remove the
needle.
• Insert new needle with the flat side of the
needle to the back, up into clamp E as far as
it will go.
• Tighten needle-clamp screw.
- - - - - - - - - - - - 1 5