Singer 288 Manual De Uso página 87

Changing lhe Lighl Bulb
CAUTION: Disoonneet power-line plug from
eleetrical outlet before removing old bulb,
Remove face plate, as instrueted on page 79.
Removing Bulb- Press bulb into socket and at
tOO same time turn bulb in direetion shown to
unlock bulb pin. (Do not atternpt to unscrew
the light
bufb),
Note: This machine is designed to use a 15
watt maximum light bulb.
Replecing
Bulb: Press new bulb into socket,
with bulb pin entering slot of socket, and turn
it in direetion shown to lock bulb in position.
Replace face plate.
Replacing lhe Slide Plale
Vou will not have any occasion to remove the
slide plate. However, if it should accidentally
become disengaged from the machine. it is
easily replaced.
• Raise the presser foot and make sure needle
is in it s highest posit ion.
• Place slide plate in slide way with the front
edge close to, but not covering, the retaining
spri ng (as shownl.
\.. ...... - - - - - - - - - - 8 5
• With a small screwdriver. lift each enel of tOO
spring into each of the side grooves on the
underside of the plate,
•
•
Draw tOO plate gently toward vou anel fully
engage the spring.
Close slide plate.