Rear Brake - Beta EVO 2T Serie Manual De Instrucciones

REAR BRAKE

REAR BRAKE REAR BRAKE
REAR BRAKE REAR BRAKE
Check Check
Check Check Check
To check the rear brake wear, simply ob-
serve the caliper on the upper part where
it is possible to see the ends of the two pads.
The pads should have at least a 2 mm Iayer
of Iining. if this Iayer is thinner than 2 mm,
replace the pads immediately.
Note: Note: Note: Observe the times given on the Note: Note:
chart on pag. 66 when performing the
check.
Replacement Replacement
Replacement Replacement Replacement
To replace the pads, proceed as follows:
•
Disassemble the rear wheel
•
Remove the caliper from the swing arm
•
Unscrew the screw A A A A A
•
Take off the pads and replace them
•
To reassemble, proceed in the reverse
order. Apply medium thread-locking
(frenafiletti medio) to the screw A A A A A .
If the brake disk is removed, ap- If the brake disk is removed, ap- If the brake disk is removed, ap- If the brake disk is removed, ap- If the brake disk is removed, ap-
ply medium thread-locking to the ply medium thread-locking to the ply medium thread-locking to the
ply medium thread-locking to the ply medium thread-locking to the
screws when reassembling. screws when reassembling. screws when reassembling. screws when reassembling. screws when reassembling.
61
3
GB