Rear Brake - Beta REV-3 Manual Del Usuario

REAR BRAKE

REAR BRAKE REAR BRAKE
REAR BRAKE REAR BRAKE
Check Check Check
Check Check
To check the rear brake for wear, simply
observe the caliper from the rear, where it
is possible to see the ends of the two pads.
These pads should have at least a 2 mm
Iayer of Iining. if this Iayer is thinner than
2 mm, replace the pads immediately.
Note: Note: Observe the times given on the Note:
Note: Note:
chart on pag. 62 when performing the
check.
Replacement Replacement
Replacement Replacement Replacement
To replace the pads, proceed as follows:
•
Unscrew the screw A
•
Make to slip the pads towards the sock
posterior (see arrow), favoring the spill-
age of the pads.
•
Remove the pads and replace them
•
To reassemble, proceed in the reverse
order. Apply "frenafiletti medio" to the
screw A.
If the brake disk is removed, apply If the brake disk is removed, apply If the brake disk is removed, apply If the brake disk is removed, apply If the brake disk is removed, apply
Loctite Loctite Loctite to to to the the the
Loctite Loctite to to the the
reassembling. reassembling. reassembling. reassembling. reassembling.
screws screws screws when when when
screws screws when when
59
3
GB