Rear Brake - Beta URBAN 125 Manual Del Usuario

3
FRONT BRAKE
Check
To check the wear of the front brake,
visually inspect the brake pad ends by
looking at the brake caliper from the front.
The brake linings should be at least 2 mm
thick. If the linings are thinner, replace the
pads immediately.
(see section 5, "Replacements", on page
72).
Note
Carry out the check at the intervals shown
in the table on page 63.

REAR BRAKE

Check
To check the wear of the rear brake,
visually inspect the brake pad ends by
looking at the brake caliper from above.
The brake linings should be at least 2 mm
thick. If the linings are thinner, replace the
pads immediately.
(see section 5, "Replacements", on page
72).
Note
Carry out the check at the intervals shown
in the table on page 63.
2 mm
GB
56