OHAUS Adventurer SL Serie Manual De Instrucciones página 11

Adventurer SL
2.2.2 Assembly of Models AS64, AS214, AS313 (Cont.)
6.Install the top door panel.
• Insert the top door in the Draft Shield by holding the door vertically over
the top of the Draft Shield framework, as shown.
• Position the back edge of the door so that it lines up with two small hinges
located on the rear cross-member.
• Gently press the door on to the hinges, until it snaps into place.
• Tilt the door forward to close.
Top Door
Close-up view of recessed hinge on
Draft Shield cross-member
EN-7