Blowing Feature; Maintenance; Filter - RIDGID WD55000 Manual Del Usuario

Operation (continued)

Blowing Feature

Your Wet/Dry Vac has the capability to be
used as a blower for yard work, patio
cleanup and workshop applications to
blow sawdust and other debris.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.

Maintenance

Filter

NOTE: This filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for wet or dry pick up. Handle the filter
carefully when removing to clean or
installing it. Creases in the filter pleats
may occur from installation but creases
will not affect the performance of the
filter.
Filter Removal
Refer to page 5 "Filter Removal and
Installation" Section of this manual.
Filter Cleaning
Your filter should be cleaned often to
maintain peak Vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out
of your Vac. Replace it
immediately.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended hours or when using in a
noisy area.
1. Locate blowing port of your Vac.
2. Insert the Tug-A-Long end of hose into
the blowing port of the Vac.
3. (Optional) Attach extension wand to
swivel end of hose, then place the car
nozzle on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Cleaning A Dry Filter
1. For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
2. After filter removal from Vac, remove
the dry debris by gently tapping the
filter against the inside wall of your dust
drum. The debris will loosen and fall.
3. For thorough cleaning of dry filter with
fine dust (no debris), run water through
it as described under "Cleaning A Wet
Filter".
Cleaning A Wet Filter
After filter is removed, run water through
the filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage filter.
Installation
Refer to page 5 "Filter Removal and
Installation" Section of this manual.
Allow the filter to dry before storing the
Vac.
15