Connection to the Pump
Figure 23
Also the pump cable is shielded and is equipped with ferrite (see the
following picture). Pump cable length must not exceed 1,5 m.
Figure 24
The turbopump is connected to the controller through an 8-pin
connector. Pins B, C and D are the 3-phase supply to the motor, pins
A and F are connected to the temperature sensor (NTC type, 30 KΩ
resistance at 25 °C) and pin E is connected to the pump ground; pins
G and H are not connected.
TV 902 Navigator User Manual / 87-900-999-01
Technical Information
Connection to the Pump
(A)
18
285/292