Pari LC SPRINT SINUS Instrucciones De Uso página 55

burning plastic). If there is a fault in the device, it may be
possible to come into contact with live parts. This in turn
may lead to an electric shock.
• Check that an aerosol is being generated before you begin
the treatment.
• Sit in an upright position and
relax.
• Constrict one nostril.
To do this, either press one fin-
ger lightly against the side of
the nose or use the nasal plug
supplied.
Make sure that the nostril is not completely blocked (e.g.
by pressing closed with a finger) because this might cre-
ate a feeling of too much pressure.
The nasal plug has a small aperture. This aperture re-
duces the feeling of pressure.
• Press the nasal joining piece of the nebuliser against the
free nostril so that the nostril is closed tightly.
• Close your soft palate [see: Tips for closing the soft palate,
page 17].
The aerosol is automatically delivered to the paranasal si-
nuses. Therefore, you should hold your breath during the treat-
ment. In order to breathe, pause the treatment briefly.
After about 2.5 minutes, carry out the treatment as described
for a further 2.5 minutes on the other nostril. The treatment is
complete after 5 minutes in all.
Some residual fluid will remain in the nebuliser after the end
of the treatment.
– 19 –