EGO POWER+ LM2100SP Manual Del Operador página 49

Ocultar thumbs Ver también para POWER+ LM2100SP:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
The mower
stops while
mowing
The mower
does not
mulch properly
There is
excessive
vibration
The handle-
locking clamps
cannot be
closed in
position
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP/LM2100SP-FC/LM2100/LM2100-FC
Cause
The battery pack is depleted.
Mower is in overload
condition.
Mower deck is clogged with
grass and debris.
The battery or mower
circuitry is too hot. (The
power indicator on the
mower will illuminate orange
for 10 seconds.)
The side rail is retracted a
little by the pushing force
applying on the handle.
Wet grass clippings are
sticking to the underside of
the deck.
The mower is set to cut too
much grass at once.
The cutting blade is loose.
The cutting blade is
unbalanced.
The cutting blade is bent.
The motor shaft is bent.
The side rails are not fully
extended.
Solution
Charge the battery pack.
Raise the cutting height or
slow down the mowing.
Unclog the mower deck.
Raise the cutting height, or
cut a narrow swath.
Allow the battery pack or
mower to cool until the
temperature drops below
152°F (67°C).
Unlock the clamps. Fully
extend the side rails and
lock the clamps again.
Wait until the grass dries
before mowing.
Raise the deck to a higher
cutting height setting.
Tighten the blade bolt.
Balance the blade following
the instructions.
Replace the blade.
Contact the service center.
Fully extend the side rails,
then lock the clamps.
49

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Power+ lm2100sp-fcPower+ lm2100Power+ lm2100-fc

Tabla de contenido