English
Table of contents+
1 General
1.1 About this document
These Installation and Operating Instructions form an integral part of the product.
They must be kept close to the product and in readiness whenever required.
Precise observance of these instructions is a pre-condition for use of the product
for the intended purpose and for its correct operation. These Installation and
Operating Instructions conform to the relevant version of the equipment and the
underlying safety standards valid at the time of going to press.
2 Safety
These instructions contain important information which must be followed when
installing and operating the pump. It is therefore imperative that they be read
by both the installer and the operator before the pump is installed or started up.
Both the general safety instructions in the 'Safety precautions' section and
those in subsequent sections indicated by danger symbols should be carefully
observed.
2.1 Symbols and signal words used in these operating instructions
Symbols:
General safety symbol
Hazards from electrical causes
NOTE: ...
Signal words:
DANGER!
Imminently hazardous situation.
Will result in death or serious injury if not avoided.
WARNING!
The user can be exposed to (severe) injury. 'Warning' refers that harm to the
user when the user is neglecting the procedure.
CAUTION!
The product is at risk of damage. 'Caution' refers to the product when the
user is neglecting the procedures.
NOTE: A notice with useful information for the user in relation to the product. It
alerts the user to possible problems.
2
Subject to technical alterations!
WILO AG 11/2007