Setting The Light Intensity; Operation - SOPRO COMEG 284 Manual De Utilización

6.1 SETTING THE LIGHT INTENSITY

After insertion of the light cable, a logo indicating the "iris" mode will be displayed on the screen [L2].
Pressing or turning the adjustment knob [S2] enables the user to exit this mode and to release the light.
A bar graph indiquates the level of intensity will then appear [L2]
Turning the adjustment knob [S2] clockwise will increase the light intensity and turning it anti-clockwise
will reduce the intensity.
An empty bar graph indicates that the source is completely dead while a full bar graph shows that it is
delivering maximum light intensity.
The LED takes about 10 seconds to stabilise its colour temperature. It is advisable
to wait for this length of time before setting the white balance on the camera.
It is also advisable to do a white balance whenever there is a change of intensity
setting.
6.2 POWER LEVEL MEMORY
To put the LED source in "iris" mode, simply press the adjustment knob [S2]. Pressing the same button
again will restore light power to the previous setting.
In the same way, if the LED source has been disconnected from its power supply it will start up again with
the light power of the previous setting.
011563 C - 11/2013
E N G L I S H
6

OPERATION

9