Troubleshooting - SOPRO COMEG 284 Manual De Utilización

10.1 THE LIGHT [L1] IS NOT LIT WHEN SWITCHED ON
• Check that the power cord is properly connected to the electricity supply and to the device and that the
main switch [S3] on the back of the unit is in the 'on' position ("I").
• Check that the fuses [F] are in good condition (only use T800mA - 250V – UL fuses).
10.2 THE SOURCE IS LIT BUT THE FLOW OF LIGHT IS INADEQUATE
• Check the condition of your light cable and your optics.
• Check that the intensity setting is not too low.
10.3 THE FANS CONTINUE RUNNING AFTER THE LIGHT HAS GONE OUT
The light cable is disconnected.
The light source is fitted with a safety device which cuts the supply to the LED if the temperature inside
the device is too high. A pictogram depicting the status of this safety system will be displayed on the
screen. Once the temperature has fallen, the source returns to the Standby position and it can be re-used:
• Check that there is enough space around the source to ensure adequate cooling (15 cm all around the
device).
• Check that nothing is obstructing the air vents on the back and underneath the source.
The light source is in "iris mode". Press the adjustment knob [S2] or turn it in order to release the light.
If the fault persists and the device needs to be returned to our After-Sales Service, please be sure to send
it to us in its original packaging after the device has been disinfected.
10.4 LIGHT APPEARS / DISAPPEARS INTERMITTENTLY
Check that the light cable is fully engaged and the connector [C1] is properly screwed in place.
011563 C - 11/2013
E N G L I S H
10

TROUBLESHOOTING

13