DBI SALA LAD-SAF Instrucciones Para El Usuario página 14

6.2 The LAD-SAF sleeve may be cleaned using commercial parts-cleaning solvents and rinsed with warm,
®
soapy water. Light machine oil may be applied to the moving parts if required. Do not use excessive oil,
or allow oil to contact the cable clamping surfaces. Store the detachable cable sleeve in a cool, dry, clean
environment, out of direct sunlight. Avoid areas where chemical vapors exits. Thoroughly inspect the sleeve
after extended storage.
7.0 SPECIFICATIONS
7.1 All top and bottom brackets, cable guides, carrier cable, and fasteners are made of galvanized or stainless
steel. Contact DBI-SALA for material specifi cation details if required. The LAD-SAF
according to the user instructions, meets OSHA, ANSI (ANSI A14.3), CSA (Z259.2.1) and CE (EN 353-
1:2002) requirements.
8.0 LABELING
8.1 The label shown in Figure 13 must be securely attached. The following text must be fully legible:
A. WARNING: Manufacturer's instructions supplied with this product at time of shipment must
be followed for proper installation, use, inspection and maintenance. Unauthorized alteration
or substitution of system elements or components is prohibited. Do not use system with
incompatible safety sleeves. Before each use inspect system visually for defects. Formally
inspect system in accordance with instructions at least annually. Failure to heed warnings may
result in serious injury or death.
B. System Capacity
C. Inspections
D. Date of Inspection
E. Inspected By
F. Date of Next/Annual Inspection
9.0 MODELS
9.1
Model Cable Length
6160029 460 ft (140 m)
6160032 214 ft (65 m)
6160033 314 ft (96 m)
6160034 348 ft (106 m)
6160035 410 ft (125 m)
6161054 279 ft (85 m)
6191059 63 ft (19 m)
6191060 82 ft (25 m)
6191061 102 ft (31 m)
14
system, when installed
®