Ventilation - Gaggenau VI 422 611 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

en-us
Prepare Installation Space
Combining several Vario devices: The connecting strip VA
420 000/001/010/011 is required for the combination of
several Vario appliances. This is available separately as a
special accessory. Consider additional space
requirement for the connecting strip between the
appliances when making the cut-out (see installation
instructions VA 420 000/001/010/011).
Appliances can also be installed in individual cut-outs,
bearing in mind a minimum distance between the devices
of 2" (51 mm).
When combining several appliances with or without
appliance cover, you can use the appliance extensions
VA 450 110/-401/-600/-800/-900 (depending on
appliance width) to balance out dimension differences.
Drilled Hole for Control Knob
Possible types of installation:
Installation in the front of the base cabinet
Installation in the countertop next to the appliance
Installation in the countertop in front of the appliance
Note: Follow the installation instructions provided for the
control knobs.
8

Ventilation

To guarantee that the appliance works correctly, the
cooktop MUST be sufficiently ventilated.
Since the ventilation in the lower section of the appliance
requires a sufficient supply of fresh air, the cabinet must
be designed accordingly. The following is required for
this:
A minimum clearance between the rear of the
cupboard and the kitchen wall, and between the
surface of the worktop and the upper area of the
drawer.
An opening at the top to the rear of the cupboard.
If the minimum clearance of
provided at the rear of the cupboard, you must create
an opening on the underside.
/
inch (20 mm) is not
25
32

Publicidad

Tabla de contenido
loading

Tabla de contenido