Astralpool CANCUN Serie Manual Técnico. Puesta En Marcha Y Funcionamiento página 40

PRE-PROG: It is an option from the Programa MODE to use when the heat pump
it is stopped or in between 2 working periods. If we press MODE key and we select
PRE-PROG, lthe heat pump it will start working at the Setting temperature until
next working period is reached. Then it will continue working in PROGRAMA
mode. This is useful when we want to hot immediately, not waiting for next
working period.
NOTE1: Compressor will start working 30 seconds after the fan starts running.
NOTE2: All the working modes have an independent Setting temperature so everytime we
switch mode , we should check the Setting temperature.
MENU:
For every working mode, and pressing MENU key we can reach next options:
Setting temperature
It indicates the water temperature that we want to reach I the swimming pool, for instance >>> 24.5ºC <<< . By pressing
+/- the temperature can be changed in 0.5ºC increases. If we are doing this in the PROGRAMA mode, the setting
temperature will be shown as : /// 26.5 ºC /// which means that the setting temperature is temporary and that in the next
working period the setting temperature will change to set point that was introduced during the timetable settings.
Información (information) (In PRE-PROG, PROGRAMA or FILTRACIÓN modes)
o
In PRE-PROG informs about the time that will switch to PROGRAMA mode.
o
In PROGRAMA mode, informs next time the heat pump will be switched on/off.
o
In FILTRACIÓN mode indicates the filtering pump status.
Programación seminal (weekly settings):
We can set 3 working period for every day (A, B y C). In every working period we
must set initial and final time setting and the Setting temperature.
Second display line activates it by moving
means of + and –
To make it easy it is available copy and paste function :
o Set the 3 working periods for one day.
o Move on the day . (For instance. Monday)
o Copy by pressing MENU until Cp appears on the left.
o By pressing + or – we can reach the day that we want to modify (for
o Paste the 3 time settings in the new day by pressing MENU key. Once we
Internal Clock setings:
By pressing
minute. Use + and – to modify values.
5. Language selection.
6. Check and delete alarms.
By pressing the MENU key we can access sequentally to::
8. Setting temperature.
9. Information: It shows filtering pump status
10. Set the timetable of the PROGRAMA mode.
11. Time set.
12. Select working units ºC or ºF
13. Language selection.
14. Check and delete alarms.
instance Tuesday)
have finish it it appears the "=" symbol. If we want to copy the same workin
period again we must repeat the sequence.
y we can select the parameters that we want to update: day, time,
and . Values can be modified by
ENGLISH
40