General Precautions; Packaging Inspection; Operating Conditions - Astralpool CANCUN Serie Manual Técnico. Puesta En Marcha Y Funcionamiento

8.

GENERAL PRECAUTIONS

The installation, start-up and maintenance of the heat pump should be done by qualified
personnel only.
This equipment should not be exposed to inflammable substances or explosives.
For any maintenance work done on the inside of the machine, proper care and precaution
should be taken to disconnect the main equipment from the power supply. For these types of
operations, the use of protective equipment such as goggles and gloves is required.
During operation of the equipment, it is normal that the condensation produced by the
evaporation unit will produce a certain quantity of water which will have to be evacuated. The
machines have an outlet tube for this reason on the corner of the back cover which should always
be free of any obstruction and connected to a drain.
This condensation water does not have to be treated in any special manner.
9.

PACKAGING INSPECTION

The Heat Pump is packaged using RECYCLABLE MATERIALS which can withstand
even the most difficult transportation conditions. Nevertheless, an inspection of the packaging
should be done upon receipt of the equipment in order to check for any damages, and to avoid
incorrect operation of the equipment.
¡WARNING!
IT IS VERY IMPORTANEEP THE PACKAGED EQUIPMENT UPRIGHT, AND THE
PACKAGING HAS BEEN SPECIFICALLY DESIGNED FOR THIS. ALWAYS MAINTAIN IT IN A
VERTICAL POSITION.
IF THE UNIT IS DAMAGED, OR THE CONSIGNMENT IS INCOMPLETE, MAKE A NOTE
OF IT ON THE CARRIER'S BILL OF LADING AND IMMEDIATELY MAKE A CLAIM TO THE
COMPANY IN CHARGE OF SHIPPING.
The package includes the following elements:
Heating and cooling swimming pool's equipment
Owner's Manual.
Warranty.

10. OPERATING CONDITIONS

Water physical and chemical parameters must be in between:
PH..........................7.2 to 7.8
Residual Cl ...............1 to 2 ppm
Alkalinity ................. 80 to 125 ppm
Solids ...................... Lower than 3000 mg/l
Ca ...........................200 – 300 ppm
The manufacturer will not be held responsible in this case.
ENGLISH
47