GYS HAND-DUCTION Manual De Instrucciones página 13

Translation of the original instructions
HAND-DUCTION EN
Do not wear clothing that is made with metallic pocket rivets, waist band buttons, pocket
buttons, and zippers when operating the HAND-DUCTION. The HAND-DUCTION can heat
such metallic items very quickly and cause serious burns or even ignite clothing.
Always wear safety goggles when using the HAND-DUCTION.
Fumes and smoke from hot/burning adhesives are toxic. Wear a dual filter (dust and fume)
respirator mask which has been approved by the Occupational Safety and Health Administration
(OSHA), the National Institute of Safety and Health (NIOSH), or the United States Bureau of
Mines. These masks and replaceable filters are readily available at major hardware stores. Be
sure the mask fits. Beards and facial hair may keep masks from sealing properly. Change
filters often. DISPOSABLE PAPER MASKS ARE NOT ADEQUATE.
Wear heat-resistant gloves when using the HAND-DUCTION. The HAND-DUCTION heats
metal very quickly. You can burn your hands and fingers when trying to remove parts from
hot metal surfaces.
The HAND-DUCTION can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
C. Electrical Safety Rules
Do not use the HAND-DUCTION in the rain, moisture or immerse in water. Exposing the
HAND-DUCTION to water or other liquids may cause an electrical shock hazard.
The power cord of the HAND-DUCTION shall be plugged into a GFI protected outlet that
provides 230 VAC - 50/60 Hz..
Do not abuse the electrical cord. Never use the cord to carry the HAND-DUCTION. Keep the
cord away from heat, oil, sharp edges and/or moving parts. Do not use the HAND-DUCTION
if the cord is damaged. Cords cannot be repaired, only replaced. Damaged cords create
electric shock hazards.
Disconnect the HAND-DUCTION power supply cord from the outlet before changing any of
the applicators.
Unplug the HAND-DUCTION from the power supply outlet or cord when not in use.
13