GYS HAND-DUCTION Manual De Instrucciones página 16

Translation of the original instructions
USING THE PREFORMED COIL™
Function: The Preformed Coil™ (5) is used to heat nuts, fasteners, caulking removal, frozen door hinges, exhaust
manifold bolts, truck under bed bolts, Sensors (O²) etc.
A. Loosening Corroded, Rusted and "Frozen" Nuts and Bolts ≤ 3/4"
Step 1 Perform the "Preparation for Use" instructions.
Step 2 Push the activation switch to operate the HAND-DUCTION.
Step 3 Bring the Preformed Coil™ around the frozen nut, initially for only two seconds, back it away, and try
to remove the nut with a wrench or socket. If it is still frozen, apply the Preformed Coil™ for another two
seconds, and then try the wrench again. There is usually no reason to heat a nut to a red-hot condition in
order to free it from the corrosion holding it to the bolt.
USING THE U-FORM COIL™
Function: The U-Form Coil (7) can be shaped to perform any of the previous coils jobs, custom part removal, and Hail/
Soft dent removal.
A. Loosening Corroded, Rusted and "Frozen" Nuts and Bolts >3/4"
Step 1 Perform the "Preparation for Use" instructions.
Step 2 Configure the coil to the size nut by wrapping it around a socket piece for that nut.
The more coil winds you can get the faster it will heat.
Tip:
Step 3 Insert both ends of the U-Form coil into the electrodes and tighten Twist-Lock™.
Step 4 Bring the U-form™ Coil around the frozen nut, initially for only two seconds, back it away, and try
to remove the nut with a wrench or socket. If it is still frozen, apply the U-Form Coil™ for another two
seconds, and then try the wrench again. There is usually no reason to heat a nut to a red-hot condition in
order to free it from the corrosion holding it to the bolt.
B. Heat Shrinking Hail / Soft Dents in Sheet Metal
Step 1 Perform the "Preparation for Use" instructions.
Step 2 Configure the Coil to look like the diagram on the right.
Step 3 Holding the U-form coil ½ to 1 inch above a dent, move it in a small circular motion and gradually
bring it closer to the dent, but keeping it around the outside of the crown of the dent. As soon as the dent
shrinks, back the U-Form Coil away quickly and cool the treated dent with a damp rag. If
the dent sucks in you are heating the crown or not far enough around the outside of the
crown. Repeat the procedure until removed completely.
Once a puff of smoke releases from the dent immediately remove the U-Form Coil
Tip:
from the area. This is the point at which the paint will start to bubble. Also be careful on
white and light colored finishes, these lighter paints tend to yellow sooner than darker
colors.
Trouble Shooting:
metal or the metal has been stretched to far.
16
HAND-DUCTION
The life of the Preformed Coil™ can be extended by only heating objects enough
to break the frozen rust bond. The insulation of the coil will eventually burn
through when holding directly to hot nuts.
If the dent doesn't seem to want to shrink, this may be because there is a crease in the
EN