Cleaning Instructions; Warranty And Repair - GYS HAND-DUCTION Manual De Instrucciones

Translation of the original instructions
DISASSEMBLY AND STORAGE
Step 1 When you are finished working, turn the power OFF by releasing the activation switch (9) and make
sure that the internal fan stops.
Step 2 Disconnect the plug (3) from the service outlet or extension cord.
Step 3 Place unit and coils into foam cutouts in storage case.

CLEANING INSTRUCTIONS

A. Proper Cleaning Care
Step 1 Make sure unit is off and unplugged. Use a dry, clean, non-abrasive cloth or paper towel to remove
grease, oil, and other dirt from the inverter, tools, and electrical cords before returning them to the storage case.
Step 2 For grease, oil and dirt that is more difficult to remove use generally available nonvolatile automotive
interior cleaning products.
Allow all components to dry completely before using the HAND-DUCTION.
A. Improper Cleaning Care
 Do NOT immerse any components of the unit in water or a cleaning solution.
 Do NOT spray the unit with a stream of water from a hose, or wash any parts under a stream of water
from a faucet, hydrant or shower.
 Do NOT clean any components with volatile organic compounds such as gasoline, benzene, kerosene,
methyl ethyl ketone (MEK), fuel oil, brake part cleaners, paint remover and thinners, varnish removers,
plastic adhesive solvents, etc. These substances are fire hazards and will harden or dissolve the polymer
materials used in the HAND-DUCTION components.
 Do NOT use heat guns, space heaters, torches, microwave or gas ovens, etc. to dry the components of
the HAND-DUCTION after cleaning.

WARRANTY AND REPAIR

The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
18
HAND-DUCTION
Turn unit off and allow the unit and all working coils to cool for at least 30
minutes before disassembly, cleaning or storage. Handling the unit or parts
before they have cooled may result in injury; storage of unit while still hot may
result in damage to equipment or pose a fire hazard.
EN