Menu Navigation - Swarovski Optik EL Range Manual Del Usario

note:
Setting the twist-in eyecups and eye relief precisely helps
to ensure maximum viewing comfort for the display (see
chapter 3.1. and 3.2.).
3.5. adjusting thE focus
To get your object into focus, sim-
ply turn the focusing wheel from
the shortest focusing distance (see
technical data sheet) to infinity.
4.
OPERATION
4.1. singlE mEasurEmEnt
The aiming mark will appear
when the measurement button is
pressed briefly. After the button is
released, the range measured is
shown on the display. For optical
safety reasons to protect people in
the vicinity, another measurement cannot be taken until
about 2 seconds have elapsed. During this safety pause,
a continuous series of minus symbols appears on the
display. Measurement is in progress.
4.2. scan modE
Scan Mode is used to continually
measure the range of moving tar-
gets. The instrument switches to
Scan Mode automatically if the
measurement button is held down
for over 3 seconds.
28 EL RANGE / EN EL RANGE / DE
In Scan Mode, measurements will be taken continually
until the measurement button is released (max. 120
seconds). The maximum range of Scan Mode is approx.
1,000 m.
5.

MENU NAVIGATION

5.1. disPlay
4. Angle symbol (<)
5. Display in metres (M) or yards (Y)
6. Degree symbol (°)
5.2. additional functions and ProgrammEs
The following programmes (P) are available:
P1 Individual brightness settings
P2 Information shown on lower display row:
- P2 off (lower display row off)
- Corrected ballistic shooting distance
(angle-dependent) (Display: CAL)
- Angle in degrees (Display: <)
P3 Toggle metres/yards
P4 Automatic brightness adjustment (on/off)
factory settings:
- P1: Level 3
- P2: Off
- P3: Metre
- P4: On
EL RANGE / EN EL RANGE / DE
1. Aiming mark
2. Display of the measured
range in metres or yards
(4-digit)
3. Measured angle in
degrees or corrected
shooting distance
29