Installation Procedure - Gaggenau AL 400 721 Instrucciones De Instalación

Installation Procedure

1 Before inserting the appliance into the cut-out of
the countertop, remove the following transport
locks:
‒ 2 plates on the front side of the appliance
‒ 2 fastening screws on the underside of the
appliance
Plug holes on the underside of the device with
the locking cap.
Note: Keep the transport locks. Re-mount transport
locks before transporting the appliance (e.g. during a
move).
2 Push appliance from above into the cut-out of the
countertop.
Note: Make sure that the seal on the underside of
the cover does not slide.
3
Only for built-in installation: Before joining, make
sure to perform a function test!
gap with a suitable, temperature-resistant silicone
glue (e.g. Novasil ® , Pactan
with a smoother recommended by the
manufacturer. Heed the processing instructions
for the silicone glue. Only start up the appliance
after complete drying of the silicone glue (at least
24 hours, depending on the room temperature).
NOTICE: Unsuitable silicone glue causes
permanent discoloration with natural stone
countertops.
4 Insert appliance evenly into the cut-out. Press
firmly from above into the cut-out.
Notes
‒ The appliance must sit fast in the cut-out and
may not slide (e.g. during cleaning). For cut-
out width on the upper tolerance limit, if
necessary fasten ledges on the side in the cut-
out.
‒ Remove both plastic parts on the left and right
of the cover.
Join surrounding
® ). Smooth seal joint
9