Troy-Bilt 208cc FLEX Manual Del Operador página 18

Propelling the Power Base Forward
To propel the power base forward, si ply pull up slowly on the
Drive Control Lever. To stop, si ply release the lever.
WARNING!
equivalent of the gas pedal on a car. Pulling up on
the lever quickly will cause the power base to
accelerate quickly.
Disconnecting an Attachment
Fully stop the power base engine before atte pting to perfor
any aintenance steps or uncoupling of the attach ent.
WARNING!
engine and re ove the key prior to atte pting to
uncouple of the power base fro
1. Fully stop the power base, and wait for all
co e to a co plete stop.
2. Release the Attach ent Control Lever.
WARNING!
Attach ent Control Lever before atte pting to
couple or uncouple the power base fro
attach ent. Failure to do so can result in da age to
your equip ent.
3. With both hands on the handle grips,
Lock™ kickstand into the unlock (Down) position, see
Figure 5-9.
4. Lift up on the handles, pivoting the power base forward
and ove the power base backwards, away fro
attach ent.
5. Park the power base utilizing the deployed Latch'n Lock™
kickstand, which should still be in the downward position.
18 S 5— O
ECTION PERATION
The Drive Control Lever is the
Always turn off the FLEX™ Power Base
the attach ent.
oving parts to
Always be sure to release the
an
ove the Latch'n
Figure 5-9
the