JANE DRIVE Manual De Instrucciones página 46

NOTE: Always remember to secure the child with the safety
!
harnesses fastened correctly. The straps should fit snugly,
and must not be twisted, and should hold the pelvis area (lap
belt) and the shoulders (torso belt) secure.
Adjusting the integral straps
The height of the shoulder straps should be adjusted as the
child grows. Check that the shoulder straps are at the right
height when the child is sitting in the seat correctly. They should
be slightly above the child's shoulders. DRIVE has 4 strap posi-
tions in this set-up, when the strap height is adjusted the head-
rest will move.
To change the strap height follow the steps below:
• Pull the lever found on the back of the backrest (4), this will
unlock the headrest position.
• Move the headrest (3) to the right position for the child and
release the lever. Move the headrest until you hear it click indi-
cating it is locked into place.
46
EN
3
.a
Pull the headrest to check it is locked securely in place.
NOTE: Adjust this height as the child grows. Note that, de-
!
pending on the space in your vehicle, the maximum height of
the headrest may touch the roof of the car. Try reclining the
safety seat to avoid this issue.
Removing the safety seat when it has been installed with ISOFIX
and the Top Tether strap:
• Loosen the Top Tether by pressing the button on the tightener.
1
.a. The indicator on the tightener will display a red line. Re-
lease the hook from the ring of the vehicle.
• Release the hook from the ring of the vehicle.
• Loosen the tension of the ISOFIX anchors by turning the han-
dle (9).
• Release the ISOFIX anchors by pressing both release buttons
(7). The indicators on the side (8) will turn red.
• Take the safety seat out of the vehicle. The ISOFIX anchors can
be stored inside the base by turning the handle (9).
3
.b