Installation For Children From 100 To 125 Cm In Height, With The Vehicle; Installation For Children From 100 To 150 Cm In Height, With The - JANE DRIVE Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Removing the booster seat when it has been installed just with
the vehicle seat belt:
• Unfasten the vehicle seat belt buckle.
• Take the seat belt out of the belt guide on the headrest (11) to
5
release the seat.
.a
• Remove the seat.
J. INSTALLATION FOR CHILDREN FROM 100 TO 125 CM IN HEIGHT, WITH THE VE-
HICLE SEAT BELT AND ISOFIX ANCHORS (WITHOUT THE TOP TETHER STRAP)
Installing the seat in the vehicle with ISOFIX anchors (without
the Top Tether strap)
The booster seat can be secured with the ISOFIX anchors, this
gives the seat greater lateral stability.
To install it follow the steps below:
• Extract the ISOFIX anchors (6) by turning the handle (9) found
7
on the front of the base.
.a
• Guide both anchors towards the ISOFIX connection points of
your vehicle and press until both sides are locked in place. Two
green indicators on the sides of the base (8) will confirm that
48
EN
they are correctly locked in place. If one or both or the indica-
tors are red, try again.
5
.b
• Turn the handle (9) the other way to adjust the safety seat so it
is positioned firmly against the backrest of the vehicle seat.
Removing the booster seat when it has been installed with the
vehicle seat belt and the ISOFIX anchors:
• Unfasten the vehicle seat belt buckle.
• Take the seat belt out of the belt guide on the headrest (11) to
release the seat.
• Loosen the tension of the ISOFIX anchors by turning the han-
dle (9).
• Release the ISOFIX anchors by pressing both release buttons
(7). The indicators on the side (8) will turn red.
• Take the safety seat out of the vehicle. The ISOFIX anchors can
be stored inside the base by turning the handle (9).
K. INSTALLATION FOR CHILDREN FROM 100 TO 150 CM IN HEIGHT, WITH THE
VEHICLE SEAT BELT AND ISOFIX ANCHORS AND THE TOP TETHER STRAP
Installing the booster seat with backrest in the vehicle with the ISO-
FIX anchors and the anti-rotation strap (Top Tether)
7
.b
5
.b
5
.a
7
.c

Publicidad

Tabla de contenido
loading

Tabla de contenido