Adjusting The Height Of The Headrest; Reclining The Seat; Recommendations - JANE DRIVE Manual De Instrucciones

When taking the child out of the seat you don't need to take the
seat belt out of the guide on the headrest (11), so it is easier to
fasten the child in again next time the seat is used.
M. ADJUSTING THE HEIGHT OF THE HEADREST
Once the integral straps have been concealed, the height of the
headrest can be adjusted using the handle on the back of the
headrest at the top (15). To release it, pull the button upwards,
when you release it the headrest will lock into the nearest po-
sition.
• Place the child in the booster seat, and adjust the height of the
headrest using the button (15). The seat belt should be slightly
6
above the child's shoulder.
!
NOTE: Adjust this height as the child grows.
N. RECLINING THE SEAT
To offer the child greater comfort the seat can be reclined. Maxi-
mum protection is provided when the seat is not reclined.
50
EN
.a
The DRIVE seat is reclined using a lever found on the front part
of the seat (12). It has 3 positions. This action, when using the seat
as a booster seat with backrest, means the 3-point seat belt of
the vehicle has to be adjusted. In this case, carry out this ma-
noeuvre when the vehicle is stationary.
• To recline the seat, pull the lever and slide the seat to the re-
quired position.
NOTE: Do not adjust the reclining position while the child is
!
using the seat. When changing the reclining position of your
DRIVE you need to adjust the tension and length of the seat
belt and the Top Tether anti-rotation strap. Only adjust the
DRIVE when the car is stationary.
O. RECOMMENDATIONS
•Keep this instruction manual for future reference. Always store
it in the compartment on the back of the seat (13).
•Inside the vehicle make sure that all luggage and any other