Electrical Connections; The First Wash Cycle; Technical Details; Water Connections - Indesit IWME 106 Instrucciones De Uso

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the
washer dryer. If this is not the case, replace the
socket or the plug.
! The washer dryer must not be installed ou-
tdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washer dryer has been installed, the
electricity socket must be within easy reach.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, setting the 90°C pro-
gramme without a pre-wash cycle.

Technical details

Model IWME 106
59,5 cm wide
Dimensions 81,5 cm high
54,5 cm deep
Capacity from 1 to 6 kg
Please refer to the technical
Electric
data plate fixed to the ma-
connections
chine.
maximum pressure 1 MPa
Water (10 bar) minimum pressure
0.05 MPa (0.5 bar) drum
connections
capacity 52 litres
Spin speed up to 1000 rpm
Test wash
cycles in
accordance Programme
with re- dard 60°C;
Programme
gulations
1061/2010 dard 40°C.
and
1015/2010.
This appliance is compliant
with the following European
Community Directives:
- 2004/108/CEE (Electroma-
gnetic Compatibility)
- 2006/95/CE (Low Voltage)
- 2012/19/EU
GB
: Cotton stan-
: Cotton stan-
17