Personalisations; Setting The Temperature; Setting The Spin Speed; Functions - Indesit IWME 106 Instrucciones De Uso

Personalisations

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table).
The temperature can be lowered, or even set to a cold wash ( ).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cottone 1000 rpm
Synthetics 1000 rpm
Wool 800 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for each
programme.
Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by conti-
nuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set
frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note:
- If the function selected is incompatible with the programme set, the button will flash and the function will not be enabled.
- If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled.
Option Effect
Delays the start of the
wash by up to 9 hours.
Delay Timer
Bleaching cycle de-
signed to remove the
toughest stains.
Bleaching
By selecting this function,
the wash and spin cycles
will be modified in order
to reduce the formation
of creases. At the end
of the cycle the washing
machine will perform slow
Easy iron rotations of the drum.
Increases the efficiency
of the rinse.
Extra Rinse
Comments
Pess the button repeatedly until the LED corresponding to the desired delay is turned on.
The fifth time the button is pressed, the function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay can only be decreased if
you wish to modify it.
Please remember to pour the bleach into extra compartment 4
(see page 26).
This option is incompatible with the EASY IRON option.
To drain the water so that the laundry may be removed, press the START/PAUSE
button.
This option is incompatible with the BLEACHING option.
Recommended when the appliance has a full load or with large quantities of detergent.
GB
.
25