Batteries: Removal; The Battery Charger; Choosing The Battery Charger; Preparing The Battery Charger - IPC 512 Serie Manual De Instrucciones

•
Rotate the top cowling
•
When using the machine, follow the instructions below.

6.4.3. Batteries: removal

When removing the batteries, the operator must be equipped with suitable personal
protection devices (gloves, goggles, overalls, safety shoes, etc) to reduce the risk
of accidents. Make sure the switches on the control panel are in the "0" position
(off) and the machine is turned off. Keep away from naked flames, do not short
circuit the battery poles, do not cause sparks and do not smoke. Proceed as
follows:
• disconnect the battery wiring and bridge terminals from the battery poles.
• if necessary, remove the devices fixing the battery to the base of the machine.
• lift the batteries from the compartment using suitable lifting equipment.

6.4.4. The battery charger

Never allow the batteries to become excessively flat as this could damage them

6.4.5. Choosing the battery charger

Make sure the battery charge is compatible with the batteries to be charged:
tubular lead batteries: you are recommended to use an automatic battery charger.
However, you should always consult the battery charger manufacturer and manual to
confirm the choice.
gel batteries: use a charger specific for this type of battery.

6.4.6. Preparing the battery charger

If you wish to use a battery charger not provided with the machine, you must fit it with the
connector supplied with the machine.
To install the connector, proceed as follows:
• remove about 13 mm of protective sheath from the red and black wires of the battery
charger;
• insert the wires into the connector contacts and squeeze them forcefully with suitable
pliers;
• respect the polarity (red wire + black wire –) when inserting the wires into the connector.
• Insert the wired-up connector into the connector in the machine compartment.
! DANGER
IMPORTANT
irreparably.
ENGLISH
13