Batteries: Removal; Choosing A Battery Charger; Preparing The Battery Charger - IPC CT80 Manual De Instrucciones

Batteries: removal

When removing the batteries, the operator must be equipped with suitable personal protec-
tion devices (gloves, goggles, overalls, safety shoes, etc.) to reduce the risk of injury. Make
sure the switches on the control panel are in the "0" position (off) and the machine is turned
off. Keep away from naked flames, do not short circuit the battery poles, do not cause sparks
and do not smoke. Proceed as follows.
► Disconnect the battery cables and bridge terminals from the battery poles.
► If necessary, remove the devices fixing the battery to the base of the machine.
► Lift the batteries from the compartment using suitable lifting equipment.

Choosing a battery charger

Make sure the battery charger is compatible with the batteries to be charged.
Tubular lead batteries: an automatic charger is recommended. Consult the battery charger manu-
facturer and manual to confirm the choice.
Gel batteries: use a charger specific for this type of battery.
Use CE-marked battery chargers that comply with the relevant product standards (EN60335-
2-29), featuring double or reinforced insulation between input and output, and a SELV output

Preparing the battery charger

If you wish to use a battery charger not provided with the machine, you must fit it with the connector
supplied with the machine.
The connector supplied for the external battery charger is suitable for cables with a minimum cross-
section of 16 mm .
2
Proceed as follows to fit the connector:
Remove about 13 mm of protective sheath from the red and black cables of the battery charger.
Insert the wires into the connector contacts and squeeze them forcefully with suitable pliers.
Respect the polarity (red wire + black wire –) when inserting the wires into the connector.
! DANGER!
! DANGER
circuit.
GB 16