Anti-Theft System; Installation Procedures - NORAUTO SOUND NS-211 Manual Del Usuario

INSTALLATION GUIDE
Installation Opening
This unit can be installed in any dashboard
having an opening as shown below. The
dashboard should be 4.75mm - 5.56mm thick
in order to be able to support the unit.
If the opening is too small, carefully cut or file
as necessary until the sleeve easily slides into
the opening. Do not force the sleeve into the
opening or cause it to bend or bow. Check for
sufficient space behind the dashboard for the
unit chassis.

Installation Procedures

1. If relevant, remove any other audio system
from the car.
2. I n s e r t t h e m o u n t i n g s l e e v e i n t o t h e
dashboard. Fix it firmly in place by folding
down the metal tabs.
3. Perform the required electrical connections.
4. Then check that everything works before
installing the main unit.
5. Remove the two screws on the top of the
unit, otherwise, the unit will not work.
6. Install the car radio in the dashboard using
the supplied screws (M5x6mm).
7. Attach the outer trim frame.
If you are not sure how to install this unit
correctly, contact a qualified technician.
Mounting bolt
Rubber cushion
Remove the
two screws
Trim plate
Mounting sleeve
Main unit

ANTI-THEFT SYSTEM

This unit is equipped with a detachable panel.
Removing this panel makes the radio totally
inoperable.
Remove the detachable panel
1. Switch off the power of
the unit.
2. Press button to flip
down the panel.
3. Hold the right part of the panel. Press to
the left side, then take off the panel.
4. Place the panel into the case and take it
with you when you leave the car.
Install the panel
1. Hold the panel and
e n s u r e t h e p a n e l
faces downward, and
set left side of the
panel in the panel
bracket, then set the
right part.
2. Press the top of panel
until it locks.
Remove the unit
1. Remove the panel and
the trim plate.
2. I n s e r t b o t h R e m o v a l
Keys into hole on the
front of the set until they lock.
3. Pull out the unit.
Reset
Press the RESET button with a pointed object
to reset the unit to the original status.
Note: Press the RESET button will erase the
clock setting and stored stations.
58
1
2