Connect A Probe; User Interface And Navigation - Hach sensION+ Serie Manual Del Usuario

For battery installation, refer to
Note: A tool such as a flat screwdriver may be necessary the first time the cover is
removed.
Make sure that the cover is tightly closed to maintain the IP67 enclosure
rating.
Figure 1 Battery installation

Connect a probe

1. Plug the probe into the meter
2. Push the connector so that the alignment pin goes into the groove on
the female connector.
Note: Do not turn the connector.
6 English
Figure 1.
(Figure 2).
Figure 2 Probe connection

User interface and navigation

User interface
Figure 3 Keypad description
1 DISPLAY LIGHT key
2 DATALOG key
3 UP key
4 MEASUREMENT key
5 DOWN key
6 ON/OFF
7 CALIBRATION key