Irritrol Junior Plus 2 Manual De Instrucciones página 2

PROGRAMMING STEPS
Irrigation programming consists of 3 parameters:
1
Watering time for each station
Each station can be assigned to a program by entering watering duration in that program.
In a cycle, all stations belonging to a program will open sequentially, one after the
other. Stations can be assigned to both programs.
SET TIME/DAY
NOTE
If you press ON/+ or OFF/- continuously, the digits will advance quickly.
*
1
WATERING TIME
PI (Program 1)
2
IRRIGATION DAYS
DAYS ON/OFF
PI
DAY CYCLE
(Interval)
2
Irrigation days
If is not on SET TIME/DAY, press NEXT STEP until
•
up with SET TIME/DAY.
Press DAY/STN until arrow points to current day.
•
Press ON/+ or OFF/- to set current time.
•
Press NEXT STEP to enter watering time.
•
Enter watering time to all stations you wish to assign to this
•
program. Each station can be programmed to have a different
watering time.
Press ON/+ or OFF/- to set your watering time.
•
Press DAY/STN to select your next station in this program.
•
Repeat for all the stations.
•
Press NEXT STEP to advance to the next programming step.
•
You can either select the days of the week you wish to water
•
or select days cycle. The arrow pointing under SU is flashing.
Press ON/+ for the days you wish to water.
•
Press OFF/- for the days you wish to skip irrigation, or
•
Press DAY/STN until arrow points to days cycle [
•
Press ON/+ or OFF/- to select your days cycle.
•
Both digits will advance together. The right digit displays the
•
selected days cycle, the left digit displays the remaining days
to irrigation. If 1 is selected = Every day. 2 = Every other day.
3 = Once every 3 days (1 to 14 day cycle possible).
3
2
STN=Station (Zone)
Program start time
lines
]