Publicidad
Idiomas disponibles
Idiomas disponibles
3
PROGRAM
START TIMES
START 1
PI
The first station of program 1 will start watering at the time you selected and the other
stations in this program will operate sequentially, one after the other, automatically.
**
To enter program 2 (PII) press NEXT STEP and repeat from
program 2, press NEXT STEP continuously until arrow points to MANUAL.
MANUAL
NOTE
To get to Manual
mode from any
position, press
NEXT STEP
continuously.
AUTO RUN/OFF
(OFF)
WATER BUDGET
PI & PII
Press DAY/STN if you wish to return to days of the week.
•
Press NEXT STEP to program the start time.
•
Press ON/+ or OFF/- to set the time.
•
Press NEXT STEP to set next start time.
•
NOTE
Only one start time is required to start a program.
Two MANUAL modes are available:
Manual Start Per Station (only that station)
Press ON/+ to open the station (arrow pointing to the station
•
number will stop flashing). Press OFF/- to turn off the station.
Press DAY/STN to select your next station.
•
If you leave the station ON, it will close after its' programmed
•
watering time. The first priority is the watering time for program 1,
the 2nd priority is the watering time for program 2, and if no
watering time was programmed, the station will open for 2 minutes.
After the station is closed, the controller will skip to AUTO mode.
Press NEXT STEP to select the next manual mode.
Manual Start Per Program — Semi-Auto
In this mode, you can turn on all the stations programmed in
program 1 or program 2. The valves will open in sequence.
The 1st programmed station in this program will flash.
Press ON/+ to start the cycle and OFF/- to terminate it.
•
Press NEXT STEP to select program 2. Repeat as in program 1.
•
Press NEXT STEP to advance to AUTO RUN mode.
•
Will display Time & Day, open station and power failure.
Press OFF/- in AUTO RUN mode to suspend all watering.
•
OFF will appear in the display.
Press ON/+ in AUTO RUN mode to resume watering.
•
To either increase or decrease watering time for all stations in a
program, use percentage scaling. Your current setting of
watering time represents 100%. You can get to the Water
Budget position from any Watering Time position.
Press DAY/STN until you pass all stations and the display
•
100
shows
and the active stations in that program are flashing.
Press ON/+ to increase and OFF/- to decrease the percentage
•
from 10% to 200%.
i.e.: If stations in PI are set at 10 minutes run time and you increase the
percentage to 150%, they will now run 15 minutes each.
Press NEXT STEP to skip to MANUAL mode.
•
3
*
**
to
. To skip
Publicidad
